
HEATING (TOP PLATTEN)
Consisting of 40 Individual infra-red
 elements in 20 zones
 controlled by energy regulators.
Built in stand-by temp. at dwell
position.
1 off pyrometer reading  material
temperature during heating cycle
interacting with plc to continue
process at preset soak temperature.

FORMING SECTION
Pre-vacuum grooved aluminium
drape table with integral water
cooling and vacuum held tooling.
Daylight 250mm as standard.

CLAMPING
Rear spring compensated pivot
with 100mm bore twin
actuators sealed with silicone
rubber fully adjustable 
clamping.

VACUUM
Integral pump & tank
producing 200% evacuation.

CUTTING
Twin toggle hydraulic cutting
press 250 tonne working 
pressure.

COOLING
Four turbo fans adjustable
 to cover entire forming area
1 off pyrometer reading 
sheet temp. to end cycle
 at pre-selected temperature.

Guarding
Conforms to CE Harmonised
standards.

FINISH
In two tone grey.

The model as standard includes 20zone heater layout, temperature controlled tooling and pyrometer reading of sheet, ensuring each skin is identically formed well within the temperature recommended by sheet manufacturers.

Incorporating vacuum hold aperture plates and tooling enabling fast turnaround on tool size changes,

Forming area .................................. Max 750 x 500
Forming area ................................. Min 500 x 500
Electrical Supply Required........... 32 amp per phase + 32amp N
Compressed Air ........................... .80 psi filtered to 50 micron
Air consumption ............................22 cfm
DIMENSION
Height ......................................... 2700m
Depth ......................................... 1950mm
Width .......................................... 8300mm