
HEATING (TOP PLATTEN)
Consisting of 72 Individual quartz
elements in 36 zones
controlled by Triacs via v.d.u.
Built in stand-by temp. at dwell
position.
1 off pyrometer reading  material
temperature during heating cycle
interacting with plc to continue
process at preset soak temperature.

FORMING SECTION
Pre-vacuum grooved aluminium
drape table with integral water
cooling and vacuum held tooling.
Daylight 160mm as standard.

CLAMPING
Vertical acting clamp
with Four 80mm bore 
actuators sealed with silicone
rubber fully adjustable 
clamping.

VACUUM
Integral pump & tank
producing 200% evacuation.

COOLING
Twin turbo fans adjustable
to cover entire forming area
1 off pyrometer reading 
sheet temp. to end cycle
at pre-selected temperature.

Guarding
Conforms to CE Harmonised
standards.

FINISH
In two tone grey.

The model as standard includes 36zone heater layout, temperature controlled tooling and pyrometer reading of sheet, ensuring each skin is identically formed well within the temperature recommended by sheet manufacturers.

Incorporating vacuum held tooling enabling fast turnaround on tool size changes,

Forming area .................................. Max 900x 600
Forming area ................................. Min 300 x 200
Electrical Supply Required........... 63amp per phase + 63amp N
Compressed Air ........................... .80 psi filtered to 50 micron
Air consumption ............................22 cfm
DIMENSION
Height ......................................... 2300m
Depth ......................................... 1950mm
Width .......................................... 8300mm