Heating (Top Platten)
Consisting of 96 Individual infra-red
 elements in 48 zones
 controlled by energy regulators.
Built in stand-by temp. at dwell
position.
1 off pyrometer reading  material
temperature during heating cycle
interacting with plc to continue
process at preset soak temperature

Forming Section
Single station forming a maximum
of 2100 x 900 with 160mm
daylight
Water cooled tooling via stainless
steel bolster with feed back 
loop to plc.

CLAMPING
Rear spring compensated pivot
with 100mm bore twin
actuators sealed with silicone
rubber fully adjustable 
clamping.

VACUUM
Integral pump & tank
 producing 200% evacuation

COOLING
Four turbo fans adjustable
 to cover entire forming area
1 off pyrometer reading 
sheet temp. to end cycle
 at pre-selected temperature.

Guarding
Conforms to CE Harmonised
standards.

FINISH
In two tone grey.

The model as standard includes 48 zone heater layout, temperature controlled tooling and pyrometer reading of sheet, ensuring each skin is identically formed well within the temperature recommended by sheet manufacturers.

Incorporating vacuum hold aperture plates and tooling enabling fast turnaround on tool size changes,

Forming area .................................. Max 2100 x 900
Forming area ................................. Min 500 x 500
Electrical Supply Required........... 80 amp per phase + 80 amp N
Compressed Air ........................... 80 psi filtered to 50 micron
Air consumption .......................... 22 cfm
DIMENSION
Height ......................................... 2500m
Depth ......................................... 2700mm
Width ......................................... 2600mm